Mi objetivo es utilizar en el lado izquierdo la fuente PCR y en el lado derecho debería ser la fuente normal (por ejemplo, fuente ssfamily). ¿Es esto posible sin usar XeTeX? Si te preguntas por qué es necesario esto, quiero en el lado izquierdo (comandos/funciones) en el lado derecho una descripción, sin usar siempre \texttt{}.
\documentclass[a4paper]{article}
\usepackage{tabularx} % in the preamble
\usepackage[a4paper, top=3cm, bottom=3cm, left=3cm, right=3cm, marginparwidth=2cm, headsep=1.2cm]{geometry} % layout
\begin{document}
% ....
\begin{table}[ht!]
\fontfamily{pcr}\selectfont
\begin{tabularx}{\textwidth}{X X}
\textbf{Function} & \textbf{Meaning} \\
\hline
asdf & ATFD is more than a few\\
Class that is large and complex & WMC is high\\
Class that has a lot of methods that only operate on a proper subset of the instance variable set & TCC is low\\
\end{tabularx}
\end{table}
\end{document}
Respuesta1
Esto funciona perfectamente
\documentclass[a4paper]{article}
\usepackage{tabularx} % in the preamble
\usepackage[a4paper, top=3cm, bottom=3cm, left=3cm, right=3cm, marginparwidth=2cm, headsep=1.2cm]{geometry} % layout
\begin{document}
% ....
\begin{table}[ht!]
\begin{tabularx}{\textwidth}{>{\ttfamily}X X}
\textbf{Function} & \textbf{Meaning} \\
\hline
asdf & ATFD is more than a few\\
Class that is large and complex & WMC is high\\
Class that has a lot of methods that only operate on a proper subset of the instance variable set & TCC is low\\
\end{tabularx}
\end{table}
\end{document}