내 서버가 아무 이유 없이 무작위로 재부팅되기 시작했습니다.
나는 오랫동안 문제를 찾으려고 노력해 왔으며 처음에는 가상화/proxmox 또는 어떤 이유로 재부팅이 발생했다고 생각했습니다.
하지만 이제 HDD 스토리지에 문제가 있다는 의심이 들기 시작했습니다. 여러분은 2개월 된 드라이브가 이미 죽었다고 생각하시나요?
root@proxmox ~ # smartctl -a /dev/sda
smartctl 7.0 2018-12-30 r4883 [x86_64-linux-5.0.21-1-pve] (local build)
Copyright (C) 2002-18, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Enterprise Capacity 3.5 HDD
Device Model: ST4000NM0024-1HT178
Serial Number: Z4F0S45P
LU WWN Device Id: 5 000c50 091cb67e9
Firmware Version: SN06
User Capacity: 4,000,787,030,016 bytes [4.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Device is: In smartctl database [for details use: -P show]
ATA Version is: ACS-3 (minor revision not indicated)
SATA Version is: SATA 3.1, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Fri Feb 7 18:16:25 2020 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 575) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 414) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x50bd) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 082 064 044 Pre-fail Always - 159956709
3 Spin_Up_Time 0x0003 095 094 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 38
5 Reallocated_Sector_Ct 0x0033 100 100 010 Pre-fail Always - 0
7 Seek_Error_Rate 0x000f 096 060 045 Pre-fail Always - 3800350406
9 Power_On_Hours 0x0032 068 068 000 Old_age Always - 28583
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 37
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0 0 0
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 070 048 040 Old_age Always - 30 (Min/Max 29/30)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 0
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 1155
193 Load_Cycle_Count 0x0032 099 099 000 Old_age Always - 3594
194 Temperature_Celsius 0x0022 030 052 000 Old_age Always - 30 (0 23 0 0 0)
195 Hardware_ECC_Recovered 0x001a 030 003 000 Old_age Always - 159956709
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
SMART Error Log Version: 1
No Errors Logged
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 23992 -
# 2 Short offline Completed without error 00% 23991 -
# 3 Extended offline Completed without error 00% 23986 -
# 4 Short offline Completed without error 00% 23975 -
# 5 Extended offline Completed without error 00% 23968 -
# 6 Extended offline Completed without error 00% 23950 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
제가 걱정했던 점은 다음과 같습니다.
1 Raw_Read_Error_Rate 0x000f 082 064 044 Pre-fail Always - 159956709
정말 그렇습니까? 159956709 오류가 있다는 것을 올바르게 읽었습니까?
답변1
이러한 항목은 GUI smartmontools(제 생각에는 smartctl을 사용함)에서도 이해하기 어렵습니다. 전원 켜기 시간은 28,583시간이고 마지막 확장 테스트는 23,986시간이므로 걱정된다면 다시 실행할 수 있습니다. 해당 테스트가 통과되고 SMART 오류 로그가 비어 있으면 드라이브는 정상이며 문제는 다른 곳에 있는 것입니다. 정말로 편집증이 있는 경우 제조업체/OEM 드라이브 테스트 도구로 부팅할 수 있습니다(SeaTools 링크) 테스트를 사용합니다. 그러나 OEM은 드라이브가 괜찮지 않을 때 드라이브가 괜찮다고 말할 인센티브(편집증이라고 부르세요)를 갖고 있기 때문에 smartctl을 신뢰합니다(보증해야 할 수도 있기 때문에).