我是一個真正的linux新手。無論如何,問題是我的 USB 不再被識別,這真的很煩人,因為我需要從中獲取資訊。我已經閱讀了無數的線程如何手動安裝它,但我真的無法讓它工作。我希望這只是一些簡單、愚蠢的問題,你們中的任何人都可以快速幫助我解決。
這是系統日誌:
kernel: [ 6872.420125] usb 2-2: new high-speed USB device number 11 using ehci_hcd
mtp-probe: checking bus 2, device 11: "/sys/devices/pci0000:00/0000:00:1d.7/usb2/2-2"
kernel: [ 6872.556295] scsi8 : usb-storage 2-2:1.0
mtp-probe: bus: 2, device: 11 was not an MTP device
kernel: [ 6873.558081] scsi 8:0:0:0: Direct-Access SanDisk Cruzer 8.01 PQ: 0 ANSI: 0 CCS
kernel: [ 6873.559964] sd 8:0:0:0: Attached scsi generic sg3 type 0
kernel: [ 6873.562833] sd 8:0:0:0: [sdc] 15682559 512-byte logical blocks: (8.02 GB/7.47 GiB)
kernel: [ 6873.564867] sd 8:0:0:0: [sdc] Write Protect is off
kernel: [ 6873.564878] sd 8:0:0:0: [sdc] Mode Sense: 45 00 00 08
kernel: [ 6873.565485] sd 8:0:0:0: [sdc] No Caching mode page present
kernel: [ 6873.565495] sd 8:0:0:0: [sdc] Assuming drive cache: write through
kernel: [ 6873.568377] sd 8:0:0:0: [sdc] No Caching mode page present
kernel: [ 6873.568387] sd 8:0:0:0: [sdc] Assuming drive cache: write through
kernel: [ 6873.574330] sdc: unknown partition table
kernel: [ 6873.576853] sd 8:0:0:0: [sdc] No Caching mode page present
kernel: [ 6873.576863] sd 8:0:0:0: [sdc] Assuming drive cache: write through
kernel: [ 6873.576871] sd 8:0:0:0: [sdc] Attached SCSI removable disk
先致謝
答案1
嗯,從日誌來看,可能是USB設備的分區表混亂了。
apt-get install -y testdisk
testdisk /dev/sdc
並嘗試按照螢幕上的指標掃描並重新建立分區表。
如果問題並不像與硬體相關的問題那麼嚴重,這可能會有所幫助。