Realtek AC600 Linux 設定

Question

我正在嘗試在我的 arch-linux 電腦上安裝 wifi dongle。

當我插入它時，它沒有檢測到：

# ~ ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp3s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000
    link/ether bc:5f:f4:cf:b0:f2 brd ff:ff:ff:ff:ff:ff

因此，正如 arch wiki 上所述，我安裝dkms並rtl88xxau-aircrack-dkms-git打包了。

完成此操作後，我可以看到該設備：

# ~ ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp3s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP mode DEFAULT group default qlen 1000
    link/ether bc:5f:f4:cf:b0:f2 brd ff:ff:ff:ff:ff:ff
3: wlp0s29u1u3: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN mode DEFAULT group default qlen 1000
    link/ether 34:e8:94:ca:8f:05 brd ff:ff:ff:ff:ff:ff


# ~ iw dev
phy#0
    Interface wlp0s29u1u3
        ifindex 3
        wdev 0x1
        addr 34:e8:94:ca:8f:05
        type managed
        txpower 0.00 dBm

但現在，當我嘗試把它放出來時，我得到：

# ~ ip link set wlp0s29u1u3 up
RTNETLINK answers: Operation not permitted

rfkill 不是這裡的問題：

# ~ rfkill list
0: phy0: Wireless LAN
    Soft blocked: no
    Hard blocked: no

當然，wpa_supplicant 也沒有連接：

# ~ wpa_supplicant -c /etc/wpa_supplicant/wpa_supplicant.conf -i wlp0s29u1u3
Successfully initialized wpa_supplicant
Could not set interface wlp0s29u1u3 flags (UP): Operation not permitted
nl80211: Could not set interface 'wlp0s29u1u3' UP
nl80211: deinit ifname=wlp0s29u1u3 disabled_11b_rates=0
wlp0s29u1u3: Failed to initialize driver interface

關於問題是什麼以及如何解決它有什麼想法嗎？