2011 年底的 MacBook Pro 上的新電池無法充電

Question

• 新電池
• 新的交流電源轉接器
• 新 MagSafe 端口
• 我的邏輯板上的 MagSafe 連接埠連接器有電壓
• SMC重置
• GPU 已關閉

但是...電瓶無法充電，交流電轉接器的 MagSafe 連接器上沒有指示燈，沒有電瓶就無法啟動。插入/拔出充電器：https://youtu.be/7rnb9v6DNEo 關閉/開啟充電器時的有趣行為。

Battery Information:

  Model Information:
  Serial Number:    D861015004NDGDL3T
  Manufacturer: SMP
  Device Name:  bq20z451
  Pack Lot Code:    0
  PCB Lot Code: 0
  Firmware Version: 2
  Hardware Revision:    00aa
  Cell Revision:    2
  Charge Information:
  Charge Remaining (mAh):   544
  Fully Charged:    No
  Charging: No
  Full Charge Capacity (mAh):   7800
  Health Information:
  Cycle Count:  1
  Condition:    Normal
  Battery Installed:    Yes
  Amperage (mA):    -25
  Voltage (mV): 11350

System Power Settings:

  AC Power:
  System Sleep Timer (Minutes): 10
  Disk Sleep Timer (Minutes):   10
  Display Sleep Timer (Minutes):    10
  Wake on AC Change:    No
  Wake on Clamshell Open:   Yes
  Wake on LAN:  Yes
  Current Power Source: Yes
  Display Sleep Uses Dim:   Yes
  GPUSwitch:    2
  Hibernate Mode:   3
  PrioritizeNetworkReachabilityOverSleep:   0
  Standby Delay:    4200
  Standby Enabled:  0
  Battery Power:
  System Sleep Timer (Minutes): 10
  Disk Sleep Timer (Minutes):   10
  Display Sleep Timer (Minutes):    2
  Wake on AC Change:    No
  Wake on Clamshell Open:   Yes
  Display Sleep Uses Dim:   Yes
  GPUSwitch:    2
  Hibernate Mode:   3
  Reduce Brightness:    Yes
  Standby Delay:    4200
  Standby Enabled:  0

Hardware Configuration:

  UPS Installed:    No

AC Charger Information:

  Connected:    Yes
  Charging: No