我正在嘗試為我的 Kali Linux 機器安裝 nvidia 驅動程序，它使用預設的 nouveau 驅動程式運作良好。
我按照這個教程https://www.kali.org/docs/general-use/install-nvidia-drivers-on-kali-linux/
安裝後，顯示解析度變得很低。所以我檢查了設備狀態
lspci -s 26:00.0 –v，輸出如下
26:00.0 VGA compatible controller: NVIDIA Corporation TU106 [GeForce RTX 2060 Rev. A] (rev a1) (prog-if 00 [VGA controller])
Subsystem: Device 7377:1501
Flags: bus master, fast devsel, latency 0, IRQ 10, IOMMU group 15
Memory at f6000000 (32-bit, non-prefetchable) [size=16M]
Memory at e0000000 (64-bit, prefetchable) [size=256M]
Memory at f0000000 (64-bit, prefetchable) [size=32M]
I/O ports at e000 [size=128]
Expansion ROM at 000c0000 [disabled] [size=128K]
Capabilities: <access denied>
Kernel modules: nvidia
內核模組確實顯示了 Nvidia，但未kernel driver in use顯示。
我注意到在啟動過程中出現錯誤，
System[1]: Failed to start Load Kernel Modules因此我用systemctl status systemd-modules-load.service命令進行了檢查。輸出顯示找不到 nvidia-current 和 nvidia-current-modeset，如下所示
Loaded: loaded (/lib/systemd/system/systemd-modules-load.service; static)
Active: failed (Result: exit-code) since Thu 2022-06-02 00:54:24 HKT; 7h left
Docs: man:systemd-modules-load.service(8)
man:modules-load.d(5)
Process: 446 ExecStart=/lib/systemd/systemd-modules-load (code=exited, status=1/FAILURE)
Main PID: 446 (code=exited, status=1/FAILURE)
CPU: 10ms
Jun 02 00:54:24 kali systemd-modules-load[455]: modprobe: FATAL: Module nvidia-current not found in directory /lib/modules/5.15.0-kali3-amd64
Jun 02 00:54:24 kali systemd-modules-load[453]: modprobe: ERROR: ../libkmod/libkmod-module.c:990 command_do() Error running install command 'modprobe -i nvidia-current ' for module nvidia: retcode 1
Jun 02 00:54:24 kali systemd-modules-load[453]: modprobe: ERROR: could not insert 'nvidia': Invalid argument
Jun 02 00:54:24 kali systemd-modules-load[459]: modprobe: FATAL: Module nvidia-current-modeset not found in directory /lib/modules/5.15.0-kali3-amd64
Jun 02 00:54:24 kali systemd-modules-load[451]: modprobe: ERROR: ../libkmod/libkmod-module.c:990 command_do() Error running install command 'modprobe nvidia ; modprobe -i nvidia-current-modeset ' for module nvidia_modeset: retcode 1
Jun 02 00:54:24 kali systemd-modules-load[451]: modprobe: ERROR: could not insert 'nvidia_modeset': Invalid argument
Jun 02 00:54:24 kali systemd-modules-load[464]: modprobe: FATAL: Module nvidia-current-drm not found in directory /lib/modules/5.15.0-kali3-amd64
Notice: journal has been rotated since unit was started, output may be incomplete.
這是/lib/modules下的Nvidia相關文件
./modules/5.15.0-kali3-amd64/kernel/drivers/usb/typec/altmodes/typec_nvidia.ko
./modules/5.15.0-kali3-amd64/kernel/drivers/net/ethernet/nvidia/forcedeth.ko
除了清除所有 nvidia 軟體包並重新安裝之外，我嘗試將 nouveau 添加到nvidia-blacklists-nouveau.conf，這仍然是相同的結果。我記得我以前成功安裝過一次這個驅動程式（大約1-1.5年前），我不確定這裡出了什麼問題，歡迎任何建議。謝謝。
GPU：RTX2060 CPU：R5-2600