當我嘗試使用以下命令安裝硬碟時：
sudo mount /dev/sdd /media/jinglez/MainFiles
我收到此錯誤：
jinglez@jinglezServer:~$ mount /dev/sdd /media/jinglez/MainFiles
mount: wrong fs type, bad option, bad superblock on /dev/sdd,
missing codepage or helper program, or other error
In some cases useful info is found in syslog - try
dmesg | tail or so
根據要求，我運行了dmesg | tail返回：
jinglez@jinglezServer:~$ dmesg | tail
[ 64.337321] init: transmission-daemon main process (882) terminated with status 127
[ 64.337361] init: transmission-daemon respawning too fast, stopped
[ 64.896160] tg3 0000:02:00.0: irq 42 for MSI/MSI-X
[ 65.695028] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 65.695463] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 99.933921] systemd-hostnamed[3202]: Warning: nss-myhostname is not installed. Changing the local hostname might make it unresolveable. Please install nss-myhostname!
[ 120.906364] init: plymouth-stop pre-start process (4631) terminated with status 1
[ 377.372510] EXT4-fs (sdd): bad geometry: block count 732566646 exceeds size of device (732566381 blocks)
[ 380.264264] EXT2-fs (sdd): error: couldn't mount because of unsupported optional features (240)
[ 382.129108] EXT3-fs (sdd): error: couldn't mount because of unsupported optional features (240)
答案1
經過對一些我一無所知的事情的大力研究後，我確實找到了解決方案。
在「Google搜尋」幾乎每一行看起來像是 dmesg 中的錯誤之後，錯誤的幾何區塊是我的贏家。
377.372510] EXT4-fs (sdd): bad geometry: block count 732566646 exceeds size of device (732566381 blocks)
區塊計數超過設備區塊的大小是有意義的。然而，當我讀到我應該用它來調整它的大小時，我非常害怕，resize2fs我深吸了一口氣，然後哇！我能夠再次查看我的文件。
我知道磁碟上僅使用了大約 1.5TB 的空間，因此為了安全起見，我這樣做了：
resize2fs /dev/sdd 2500000M
然後我就可以毫無問題地安裝驅動器了！
這就是我的解決方案！