我在 eBay 上買了一台筆記型電腦，螢幕壞了，以前似乎從未打開過，打開後，我發現裡面有一個 SSD，我想格式化並使用。
Gparted（以及其他程序，包括 mkusb 和 dd）報告「讀取 /dev/sda 期間輸入/輸出錯誤」。如果我點擊忽略這些大約十次，那麼我可以在驅動器選擇彈出選擇框中看到它完全未分配。如果我嘗試在設備上建立分區，它說沒有分區表，請建立分區表。如果我這樣做，它就會掛起。我無法按照建議寫入第一個 MB這個帖子（讀/寫錯誤）使用 mkusb 或 dd。
該驅動器是英特爾蛋白石 SSD，標籤上有 PSID，因此我認為它是自加密驅動器 (SED)，但使用 sedutil-cli --scan，該驅動器被報告為不是 SED。當我嘗試啟動磁碟機時，它會出現一個鎖和硬碟符號，您可以輸入密碼。它會給你三次嘗試，然後一隻帶有斜線/圓圈的手彈出，你必須關閉並重試。當它在啟動前連接到 SATA 匯流排時，它不會讓您進入 BIOS，或在另一個磁碟機上啟動。我讓 sedutil-cli 工作的方法是從一個 USB 驅動器圖片來自 Drive Trust Alliance，然後從中啟動並將英特爾SSD放入USB外殼中，並在從隨身碟上的映像啟動後連接它。
如果我使用磁碟實用程式檢查 SMART 狀態，一切都很好。我確信該驅動器已加密，但我什至無法發現它是什麼加密，或任何格式化它以供重複使用的方法。
誰能給我任何提示嗎？將這個驅動器送到垃圾掩埋場併購買一個新驅動器似乎很浪費，只是因為我無法弄清楚這一點！
謝謝！
以下是一些可能有用的更多數據：
$ sudo hdparm -I /dev/sda
[sudo] password for frohro:
/dev/sda:
ATA device, with non-removable media
Model Number: INTEL SSDSC2BF180A4L
Serial Number: CVDA341204U11802GN
Firmware Revision: LSTi
Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0
Standards:
Used: unknown (minor revision code 0xffff)
Supported: 9 8 7 6 5
Likely used: 9
Configuration:
Logical max current
cylinders 16383 16383
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 16514064
LBA user addressable sectors: 268435455
LBA48 user addressable sectors: 351651888
Logical Sector size: 512 bytes
Physical Sector size: 4096 bytes
Logical Sector-0 offset: 0 bytes
device size with M = 1024*1024: 171705 MBytes
device size with M = 1000*1000: 180045 MBytes (180 GB)
cache/buffer size = unknown
Nominal Media Rotation Rate: Solid State Device
Capabilities:
LBA, IORDY(can be disabled)
Queue depth: 32
Standby timer values: spec'd by Standard, no device specific minimum
R/W multiple sector transfer: Max = 16 Current = 16
Advanced power management level: 254
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 udma5 *udma6
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=120ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* SMART feature set
* Security Mode feature set
* Power Management feature set
* Write cache
* Look-ahead
* WRITE_BUFFER command
* READ_BUFFER command
* NOP cmd
* DOWNLOAD_MICROCODE
* Advanced Power Management feature set
* 48-bit Address feature set
* Mandatory FLUSH_CACHE
* FLUSH_CACHE_EXT
* SMART error logging
* SMART self-test
* General Purpose Logging feature set
* 64-bit World wide name
* WRITE_UNCORRECTABLE_EXT command
* {READ,WRITE}_DMA_EXT_GPL commands
* Segmented DOWNLOAD_MICROCODE
* Gen1 signaling speed (1.5Gb/s)
* Gen2 signaling speed (3.0Gb/s)
* Gen3 signaling speed (6.0Gb/s)
* Native Command Queueing (NCQ)
* Host-initiated interface power management
* Phy event counters
DMA Setup Auto-Activate optimization
Device-initiated interface power management
* Software settings preservation
Device Sleep (DEVSLP)
unknown 78[10]
* SMART Command Transport (SCT) feature set
* SCT Write Same (AC2)
* SCT Data Tables (AC5)
* reserved 69[4]
* Data Set Management TRIM supported (limit 1 block)
* Deterministic read data after TRIM
Security:
Master password revision code = 16385
supported
enabled
locked
not frozen
not expired: security count
supported: enhanced erase
Security level maximum
4min for SECURITY ERASE UNIT. 2min for ENHANCED SECURITY ERASE UNIT.
Logical Unit WWN Device Identifier: 55cd2e404b84ac1f
NAA : 5
IEEE OUI : 5cd2e4
Unique ID : 04b84ac1f
Device Sleep:
DEVSLP Exit Timeout (DETO): 20 ms (drive)
Minimum DEVSLP Assertion Time (MDAT): 10 ms (drive)
Checksum: correct